Wireless Programming - Merlin WeatherDrive MR550EVO Installation And Operating Instructions Manual

24
WIRELESS PROGRAMMING (OPTIONAL ACCESSORIES)
Activate the opener only when door is in full view, free of obstruction and properly adjusted.
No one should enter or leave garage while door is in motion. Do not allow children to operate
push button(s) or remote(s). Do not allow children to play near the door.
NOTE: The transmitter(s) supplied with your
opener are preprogrammed by the factory.
If you purchase additional transmitters, the garage
door opener must be programmed to accept the new
remote code.
Program the Receiver to Match Additional
Transmitter Codes:
Using the "S" SAVE Button
1.Press and Hold the button on the hand-held remote
or wall button that you wish to use (1).
2.Press and release the "S" button on the opener (2).
3.Release the remote button when the courtesy light
flashes 3 times. It has learnt the code. If you release
the remote control push button before the opener
light flashes, the opener has not learnt the code.
Now the opener will operate when the remote control
push button is pressed.
To Erase all Remote Control Codes
1.Press and Hold the "S" button on the opener until the
courtesy light flashes twice, and continue holding for
approx. 8 seconds, until the courtesy light flashes
twice again.
2.Release the button, all codes are now erased.
Wireless Keypad E840
To set the keyless entry PIN:
1.Locate the "S" button on the garage door opener.
2.Press and release the "S" button. The courtesy light
will flash twice.
3.Enter a 4-digit personal identification number (PIN)
of your choice on the keypad.
4.Press and hold the ENTER button. Check to see if
the courtesy light flashes. Release the ENTER
button after the light flashes.
To change an existing keyless entry PIN:
1.Enter the existing programmed PIN that you want to
change.
2.Press and hold the # button until the courtesy light
flashes twice.
3.Enter the new 4-digit PIN of your choice, then press
the ENTER button. The light will flash once.
4.To test, enter the new PIN, then press the ENTER
button. The garage door opener will activate.
2
1 1
DN DN UP UP P P
132A2940
1
1
1 1 2 2 3 3
DN UP DN UP P P S S
132A2940
2
1 1 2 2 3 3
Flash
x 2
DN DN UP UP P P S S
132A2940
3
3
4
16
2 2 3 3
Flash
x 3
S S
or
Locate
the yellow
"S" save button
Press and release
the yellow
"S" save button
Enter a 4-digit
PIN of your
choice
? ? ? ?
_ _ _ _
Press and hold
the enter button
Opener light bulbs
blink
After the lights
blink release the
ENTER button