Merlin QuietDrive Pro Installation And Operating Instructions Manual

Merlin QuietDrive Pro Installation And Operating Instructions Manual

Garage roller door opener

Advertisement

Quick Links

gomerlin.com.au
gomerlin.co.nz
Garage Roller Door Opener
Installation and Operating Instructions
Owners Copy: Please keep these instructions for future reference
DO NOT PROCEED WITH THE INSTALLATION UNTIL READING THE
MR655EVO
This manual contains IMPORTANT SAFETY information
INSTRUCTIONS THOROUGHLY

Advertisement

Table of Contents
loading

Summary of Contents for Merlin QuietDrive Pro

  • Page 1 gomerlin.com.au gomerlin.co.nz MR655EVO Garage Roller Door Opener Installation and Operating Instructions Owners Copy: Please keep these instructions for future reference This manual contains IMPORTANT SAFETY information DO NOT PROCEED WITH THE INSTALLATION UNTIL READING THE INSTRUCTIONS THOROUGHLY...
  • Page 2 Warranty Registration To validate your warranty you must complete the registration form online at: gomerlin.com.au/warranty gomerlin.co.nz/warranty...
  • Page 3: Table Of Contents

    START BY READING THESE IMPORTANT SAFETY INSTRUCTIONS WARNING • Failure to comply with the following instructions may result in serious injury or property damage. • Read and follow all instructions carefully. • The garage door opener is designed and tested to offer safe service provided it is installed and operated in strict accordance with the instructions in this manual.
  • Page 4: Carton Inventory

    9. Door stand (not shown) 13 mm, 10 mm, 8 mm 5.5 mm DOOR REQUIREMENTS The QuietDrive Pro (MR655EVO) is suitable for spring balanced Residential Rolling garage doors with: Minimum distance from edge of curtain to edge of door bracket 45 mm •...
  • Page 5: Control Panel

    CONTROL PANEL 1. Terminal Block: used for external accessories (see chart below). Colour Polarity Comment Ref Function Push button Dry contact input for push button wired wall controls White Common Common terminal for push button, obstruction detection beams & accessory power B Common White Common terminal for push button, obstruction...
  • Page 6: Prepare & Test The Door

    TESTING THE DOOR Complete the following test to ensure your door is well balanced, and not sticking or binding: • Disable all locks and remove any ropes connected to the garage door. • Lift the door to about halfway and then release it. The door should remain spring balanced.
  • Page 7: Pinning The Door

    PINNING THE DOOR Note: A ballooning door may delay the safety reversal response and can compromise garage door security. Free curtain Ballooning Add fasteners here • To remedy any ballooning, insert the supplied self tapping metal screws into where the curtain leaves the roll. Secure these through the curtain into the drum wheel at each end of the roll.
  • Page 8 ATTACHING EXTENSION POLES (IF REQUIRED) Extension pole Optional accessory not provided • Insert the extension poles into the drive legs. • Align the holes on the extension poles with the holes on the drive legs • Using the screws provided, secure the extension poles •...
  • Page 9: Installation Procedure

    INSTALLATION PROCEDURE Do not allow people to walk under or around the door during the installation process as serious injury can occur. NOTE: The opener can be installed on either side of the door. The following instructions are for Rope RIGHT HAND INSTALLATIONS (as illustrated i.e.
  • Page 10: Adjustment & Testing

    Courtesy light: During the programming sequence, the courtesy light will flash at half strength NOTE: The QuietDrive Pro (MR655EVO) opener is factory configured for right hand installation. The opener will operate during this procedure. Make sure the door is clear of obstruction.
  • Page 11 TESTING THE SAFETY REVERSE SYSTEM The safety reverse system test is important. The garage door must reverse on contact with a 40 mm obstacle laid flat on the floor. Failure to properly adjust the opener may result in serious personal injury from a closing garage door.
  • Page 12: Install The Protector System

    • Turn the power ON and check the opener operates OK without the obstruction detection beams SAFETY FIRST! Whilst Merlin have engineered safety features into your garage door opener, we urge you to consider fitting obstruction detection beams to your new garage door opener. In many countries these devices are compulsory to assist in preventing serious injury or property damage.
  • Page 13: Audible Beep

    AUDIBLE BEEP (OPTIONAL) The QuietDrive Pro (MR655EVO) has been factory set for an audible “BEEP”. The Audible beep can be turned OFF by using the following method. • Start with the door fully CLOSED. Flash x 2 • Press and Hold both “S” and “DN” buttons...
  • Page 14: Wireless Programming

    8 seconds, until the courtesy light flashes twice again. 2.Release the button, all codes are now erased. STANDBY MODE (OPTIONAL) The QuietDrive Pro has been factory set for low standby mode (sub 1 watt usage). This will deliver the lowest possible standby power. The...
  • Page 15: Operating Your Opener

    The opener light will turn on for 3 minutes when Max. Drum Rotations: 1/ 2 the opener is activated. Memory Registers: Operating Frequency: 433.30/433.92/434.54 MHz Operating Temperature: C to -25 SPECIAL NOTE: Merlin strongly recommends that obstruction detection beams be installed on all garage door openers.
  • Page 16: Wiring

    TYPICAL WIRING DIAGRAM QUIETDRIVE PRO (MR655EVO) Information for Service Personnel green (4) grey (3) white (2) red (1) External Receiver 24 vdc white black Wired Wall Button Obstruction Detection Beams Battery of the remote control: REPLACE BATTERIES IN REMOTES The batteries in the remote have a long life.
  • Page 17: Troubleshooting

    TROUBLESHOOTING 1. The opener will not operate from either the 8. The door opens but will not close (or reverses UP/DOWN activation button or the transmitters : while closing): • Does the opener have electric power? Plug a lamp into •...
  • Page 18: Accessories

    6. Model E945M 3 Channel mini transmitter NOTE: Use of any Chamberlain Group accessories are approved to use with this opener. This includes genuine Merlin accessories. Generic compatible accessories are NOT approved for use with this opener SPARE PARTS 002A1873...
  • Page 19: Diagnostic Chart

    DIAGNOSTIC CHART Your garage door opener is programmed with self-diagnostic capabilities. The indicator LEDʼs 1 & 3 on the control panel will flash a number of times to indicate a fault code exists. DIAGNOSTIC CODE SYMPTOM POSSIBLE RESOLUTION LED 1 LED 3 The garage door opener will not Safety sensors are open circuit or wires may be cut.
  • Page 20: Warranty

    What is covered excessive use or conditions other than normal domestic use; Chamberlain warrants to the original purchaser of the Merlin QuietDrive Pro 5 problems with, or relating to, the garage door or garage door hardware, MR655EVO Roller Door Opener (Unit) that all parts of the Unit, other than...

This manual is also suitable for:

Mr655evo

Table of Contents