ergoline Vitamin D3 Operating Instructions Manual page 102

Changing presettings with the control panel
The setting mode enables you to call up operating states and make alte-
rations to current settings.
Changing to Presetting mode
– Press the buttons – and + simultaneously for at least five seconds
when the system is not in use.
appears in the display.
– Enter the code (see Page 102).
– Press the START/STOP button four times when you run the Preset-
ting mode for the first time.
briefly appears in the display, then
and the presetting value are displayed alternately (see column "On
delivery").
– By pressing the + button you scroll up to the next function (from -01-
to -35-).
– By pressing the – button you scroll down to the next function (from
-35- to -01-).
Changing presettings
Increase the preset value:
– Press and hold the START/STOP button while simultaneously pres-
sing the + button.
Decrease the preset value:
– Press and hold the START/STOP button while simultaneously pres-
sing the – button.
Reset to the last value set:
– Press the START/STOP button.
Reset to the delivered state:
(Function 1)
– See function
Note:
The sunbed will automatically return to 'idle' mode 30 seconds
after the last button was pressed.
The presettings are listed beginning on Page 104.
.
101