Usb; Reset Button; Status And Port Leds - Mellanox Technologies SX1710 User Manual

Rev 1.6
ured via the RS232 serial console port or by DHCP before use. Refer to Section 2.9.1 to view the
full procedure.
3.1.5

USB

The USB interface is USB 2.0 compliant (USB 1.0 is not supported) and can be used by MLNX-
OS software to connect to an external disk for software upgrade or file management. The connec-
tor comes in a standard USB shape.
To view the full matrix of the USB configuration options, refer to
faces, PSUs and
3.1.6

Reset Button

The reset button is located on the rear side of the system next to the fan status LEDs . This reset
button requires a tool to be pressed.
To reset the system and the CPU of its management board, push the reset button and keep it
pressed for up to 15 seconds.
To reset the system, the CPU of its management board, and the "admin" password, push the reset
button and keep it pressed for at least 15 seconds. When using a MLNX-OS based system, this
should allow you to enter without a password and set a new password for the user "admin".
3.1.7

Status and Port LEDs

See "LEDs" on page 39.
38 Mellanox Technologies
Make sure you use only FCC compliant Ethernet cables.
Fans".
Do not use excessive force when inserting or extracting the USB disk to and from the
connector.
Do not use a sharp pointed object such as a needle or a push pin for pressing the reset
button. Use a flat object to push the reset button.
Table 4, "Management Inter-
Interfaces