Tabletop Installation - Enterasys RoamAbout RBT-1602 Installation Manual

Installing the Access Point
Figure 2-26
11. To ensure that the access point is fully locked onto the bracket, gently pull on the access point
and attempt to rotate it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as described in
Step
12. If the other ends of the Cat 5 cable(s) are not already connected and the link activated, go to
"Connecting an Access Point to the Network" on page
Health" on page 2‐26.

Tabletop Installation

(For required mounting hardware and tools, see Table
1. Reverse the universal mounting bracket:
a.
2-22 Installing and Connecting the Access Point
Step 9—Locking the Bracket
Lock
10 on page 2‐21.
Unlock the universal mounting bracket from the access point by inserting the 3‐mm or
1/8‐inch screwdriver into the Unlock hole on the access point as shown in Figure
Caution: To avoid damage to the access point's lock mechanism or electronic components, do
not use excessive force when inserting a tool into the Unlock or Lock hole.
Advertencia: para evitar daños en el mecanismo de cierre del punto de acceso o en los
componentes electrónicos, no introduzca con fuerza ninguna herramienta en el agujero de
"Unlock y Lock" (abrir y cerrar).
Achtung: Beim Einsatz eines Werkzeugs zum Öffnen bzw. Verschließen des Geräts sollten Sie
von übermäßigem Kraftaufwand absehen, da dies zu Beschädigungen des
Verriegelungsmechanismus oder elektronischer Komponenten führen kann.
2‐25. Otherwise, go to "Verifying AP
2‐2 on page 2‐5.)
2‐27.