Preparing For Installation - Enterasys RoamAbout AP-2000 Hardware Installation Manual

This chapter describes basic considerations for successfully installing the RoamAbout
Access Point 2000 hardware. Before installing the Access Point (AP), you must complete
the following tasks:
Review the site requirements.
Select the location to install the AP.
Unpack the AP and check the contents of the shipment.
If installing the Access Point in a building-to-building configuration, refer to the
RoamAbout Outdoor Antenna Site Preparation and Installation Guide for the proper
antenna cabling and grounding procedures.
After you install the Access Point, refer to the RoamAbout 802.11 Wireless Networking
Guide to configure the Access Point parameters.

Preparing for Installation

Chapter 1
Preparing for Installation 1-1