Verifying Ap Health - Enterasys RoamAbout RBT-1602 Installation Manual

Verifying AP Health

Verifying AP Health
After you install the access point and enable PoE on the Ethernet cable connected to the AP, you
can easily verify the AP's status by observing the LEDs, particularly the Health LED. (See
Figure
The health or LINK LED indicates whether the access point is ready for operation.
• If the LED is green and glowing steadily, the AP has been booted successfully by the switch
and is ready for operation.
• If the LED is not steadily glowing green, contact the system administrator for the switch or, if
you are the system administrator, see Appendix
2-26 Installing and Connecting the Access Point
2‐4 on page 2‐7.)
A, Access Point Troubleshooting.