Chapter 2: Hardware Installation - Enterasys RoamAbout RBT-4102 Installation Manual

Chapter 2: Hardware Installation

To install the access point, follow the steps outlined below:
1. Select a Site – Choose a proper place for the access point. In general, the best
location is at the center of your wireless coverage area, within line of sight of all
wireless devices. Try to place the access point in a position that can best cover
its Basic Service Set (refer to
optimum performance, consider these points:
• Mount the access point as high as possible above any obstructions in the
coverage area.
• Avoid mounting next to or near building support columns or other obstructions
that may cause reduced signal or null zones in parts of the coverage area.
• Mount away from any signal absorbing or reflecting structures (such as those
containing metal).
2. Mount the Access Point – The access point can be mounted on any flat
surface, such as a desktop, a ceiling, or a wall.
Mounting on a flat surface other than wall or ceiling – To keep the access
point from sliding on the surface, attach the four rubber feet provided in the
accessory kit to the marked circles on the bottom of the access point.
Mounting on a wall or ceiling – The access point should be mounted only to a
wall or wood surface that is at least 1/2-inch plywood or its equivalent. To mount
the access point on a wall or ceiling, always use its mounting bracket. The
access point must be mounted with the RJ-45 cable connector oriented
upwards to ensure proper operation.
"Infrastructure Wireless LAN" on page 4-3). For
2-1