Flashforge DREAMER Quick Start Manual page 4

1. Open box and remove bag containing the lid,
Quick start guide, After-sales service card,
levelling card, and two build tapes.
3. Firmly grasp the two sides handles of
Dreamer. Lift it out from the carton and place
it on a stable surface. Then you will see the
Toolbox and USB cable in the shipping box.
5. Take foam out of the dreamer.
Unpacking
2. Take the power cable and two top foam
sheets out.
4. Remove the packing bag.(Tip:Save your
packaging for future transportation and
storage.)
6. Open box. Box includes dual extruder, side
panel x 2, extruder's accessory kit. Take the
dual extruder out and place it onto a clean
surface. Notes: Extruder cable bunch is short.
Please do not leave the extruder hanging by
the cable.
03