Download Print this page

Flashforge DREAMER Quick Start Manual page 12

Hide thumbs Also See for DREAMER:

1. After filament placement, thread the filament

through guide tube.

2. Insert the filament into the left extruder at a

perpendicular angle while pressing down the

spring presser. Ensure the end of the filament

has a flat surface before loading it.

1. Tap [Tools], then tap [Filament].

2. Tap [Load Left].

3. Wait for the extruder to reach operating temperature. An alert will indicate this.

4. Secure the filament with a flat cross-section and load it by inserting the filament into the

extruder at an upright angle, meanwhile press down the spring presser.

5. Filament will flow out of the nozzle. Continue loading until the filament is extruded in a

straight line.

Table of Contents