Flashforge DREAMER Quick Start Manual page 10

1. Tighten the three leveling knobs under the build platform until you cannot tighten them any more.
2. Tap [Tools], [Leveling] to start leveling.
3. The build plate and the nozzle start moving, once they suspend, you need to adjust the corresponding
knob under the right nozzle.
4. The leveling card should slide between the nozzle and build plate with some friction/resistance. If the
card slides through easily, the nozzle and build plate are too far apart. Rotate the knob clockwise to
decrease the distance between them. If the card cannot slide through, rotate the knob anticlockwise.
5. After leveling the first point, tap [OK] to continue to the next point.
6. After adjusting the three knobs and making a check when the nozzle is at the center of the plate, you
finish the build plate leveling.
How to level the build plate
09
Take the proper distance between
the right nozzle and build plate
as the standard.