5. Attach the front/rear latch plates to the host
machine.
• 4 Screws (RS tightening; M4x8)
CAUTION:
• Positioning hole shape is different between the
latch plates (front and rear).
> Latch Plate (Front): Wide Hole
> Latch Plate (Rear): Tall Hole
• Fit the latch plate in the center of the tall hole.
RS Tightening
M4x8
4x
Tall Hole
Wide Hole
6. Remove the main station lower right cover (the
removed cover and screws are not used).
• 2 Screws
2x
7. Remove the cover plate (the detached plate and the
removed screws are not used).
• 2 Screws
2x
120
6. Installation