Canon POD Deck Lite-C1 Service Manual page 116

4. Attach the latch plates (front / rear) to the host
machine.
• 4 Screws (RS tightening; M4x8)
CAUTION:
• Positioning hole shape is different between the
latch plates (front and rear).
Latch Plates (Front): Wide Hole
Latch Plates (Rear): Tall Hole
• Attach the latch plate in the center of the hole.
RS Tightening
M4x8
4x
Tall Hole
Wide Hole
5. Remove the connector cover from rear of the host
machine (the removed connector cover is not used).
■ Preparation of the POD Deck Lite
1. Attach the door stopper.
• 1 Screw ( P tightening screw; M3x8)
P Tightening
M3x8
110
6. Installation
1x