Table of Contents
Advertisement
-
o
Presser foot lever
The presser foot lever raises and lowers the presser foot.
It can be raised about 1/4" (0.6 cm) higher than the nor-
mal top position to facilitate removal of the presser foot
or to help you place heavy fabric under the foot.
Lowered position
Normal up position
Highest position
Changing the Presser Foot
CAUTION:
Turn OFF the power switch before changing the
foot. Always use the foot that corresponds to the
selected stitch. The wrong foot can cause the
needle to break.
Presser foot release lever
Groove
Pin
•
To remove:
Turn the handwheel toward you to raise the needle bar
to its highest position.
Raise the presser foot.
Push the presser foot release lever to snap off the
presser foot holder.
•
To attach:
Place the presser foot so that the pin on the foot lines up
directly below the groove of the presser foot holder.
Lower the presser foot.
Attaching and removing the presser
foot holder
CAUTION:
Turn OFF the power switch before changing the
presser foot holder.
Setscrew
Presser foot holder
Threaded hole
•
To remove:
Remove the setscrew by turning it counterclockwise with
a screwdriver.
•
To attach:
Match the hole in the presser foot holder with the
threaded hole in the presser bar. Fit the setscrew into
the hole. Tighten the screw by turning it clockwise with
screwdriver.
9
Hide quick links:
Advertisement
Table of Contents
