HP A5830 series Configuration Manual page 51

# Configure GigabitEthernet 1/0/50 to operate in full duplex mode and at 1000 Mbps, and enable
DLDP on the port.
[DeviceA] interface gigabitethernet 1/0/50
[DeviceA-GigabitEthernet1/0/50] duplex full
[DeviceA-GigabitEthernet1/0/50] speed 1000
[DeviceA-GigabitEthernet1/0/50] dldp enable
[DeviceA-GigabitEthernet1/0/50] quit
# Set the DLDP mode to enhanced.
[DeviceA] dldp work-mode enhance
# Set the port shutdown mode to manual.
[DeviceA] dldp unidirectional-shutdown manual
Configure Device B.
2.
# Enable DLDP globally.
<DeviceB> system-view
[DeviceB] dldp enable
# Configure GigabitEthernet 1/0/49 to operate in full duplex mode and at 1000 Mbps, and enable
DLDP on it.
[DeviceB] interface gigabitethernet 1/0/49
[DeviceB-GigabitEthernet1/0/49] duplex full
[DeviceB-GigabitEthernet1/0/49] speed 1000
[DeviceB-GigabitEthernet1/0/49] dldp enable
[DeviceB-GigabitEthernet1/0/49] quit
# Configure GigabitEthernet 1/0/50 to operate in full duplex mode and at 1000 Mbps, and enable
DLDP on it.
[DeviceB] interface gigabitethernet 1/0/50
[DeviceB-GigabitEthernet1/0/50] duplex full
[DeviceB-GigabitEthernet1/0/50] speed 1000
[DeviceB-GigabitEthernet1/0/50] dldp enable
[DeviceB-GigabitEthernet1/0/50] quit
# Set the DLDP mode to enhanced.
[DeviceB] dldp work-mode enhance
# Set the port shutdown mode to manual.
[DeviceB] dldp unidirectional-shutdown manual
Verify the configuration.
3.
After the configurations are complete, you can use the display dldp command to view DLDP
configuration information on ports.
# Display the DLDP configuration information on all DLDP-enabled ports of Device A.
[DeviceA] display dldp
DLDP global status : enable
DLDP interval : 5s
DLDP work-mode : enhance
DLDP authentication-mode : none
DLDP unidirectional-shutdown : manual
DLDP delaydown-timer : 1s
51