In interface view
To configure member ports for a monitor link group in interface view:
To do...
•
Enter system view
•
Enter Layer 2 Ethernet interface view or
Layer 2 aggregate interface view
•
Configure the current interface as a
member of a monitor link group
You can assign a Layer 2 Ethernet port or Layer 2 aggregate interface to a monitor link group as a
member port.
A port can be assigned to only one monitor link group.
Configure uplink ports prior to downlink ports to avoid undesired down/up state changes on the
downlink ports.
Displaying and maintaining Monitor Link
To do...
•
Display monitor link
group information
Monitor Link configuration example
Network requirements
As shown in
Device C is a smart link device, and Device A, Device B, and Device D are associated devices.
•
Traffic of VLANs 1 through 30 on Device C is dual-uplinked to Device A through a smart link
group.
Implement dual uplink backup on Device C, and make sure that when the link between Device A
•
and Device B (or Device D) fails, Device C can sense the link fault and perform uplink switchover in
the smart link group.
For more information about Smart Link, see the chapter "Smart Link configuration."
Use the command...
display monitor-link group { group-id | all } [ | {
begin | exclude | include } regular-expression ]
28:
Figure
Use the command...
system-view
interface interface-type interface-
number
port monitor-link group group-id {
uplink | downlink }
113
Remarks
—
—
Required
Remarks
Available in any view