HP A5830 series Configuration Manual page 140

[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.128
# Create a VRRP group 1 and set its virtual IP address to 202.38.160.100.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.100
[SwitchB-Vlan-interface2] quit
# Configure VLAN 3.
[SwitchB] vlan 3
[SwitchB-vlan3] port gigabitethernet 1/0/6
[SwitchB-vlan3] quit
[SwitchB] interface vlan-interface 3
[SwitchB-Vlan-interface3] ip address 202.38.160.131 255.255.255.128
# Create a VRRP group 2 and set its virtual IP address to 202.38.160.200.
[SwitchB-Vlan-interface3] vrrp vrid 2 virtual-ip 202.38.160.200
# Configure the priority of Switch B in VRRP group 2 to 110, which is higher than that of Switch A
(100), so that Switch B can become the master in VRRP group 2.
[SwitchB-Vlan-interface3] vrrp vrid 2 priority 110
Verify the configuration.
3.
To verify your configuration, use the display vrrp verbose command.
# Display the detailed information of the VRRP group on Switch A.
[SwitchA-Vlan-interface3] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 2
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
Interface Vlan-interface3
VRID
Admin Status
Config Pri
Preempt Mode
Become Master
Auth Type
Virtual IP
Master IP
# Display the detailed information of the VRRP group on Switch B.
[SwitchB-Vlan-interface3] display vrrp verbose
IPv4 Standby Information:
: Standard
: Virtual MAC
: 1 Adver Timer
: Up State
: 110 Running Pri
: Yes Delay Time
: None
: 202.38.160.100
: 0000-5e00-0101
: 202.38.160.1
: 2 Adver Timer
: Up State
: 100 Running Pri
: Yes Delay Time
: 2200ms left
: None
: 202.38.160.200
: 202.38.160.131
140
: 1
: Master
: 110
: 0
: 1
: Backup
: 100
: 0