HP A5830 series Configuration Manual page 186

Figure 50 Network diagram for VRRP-track-interface management collaboration configuration
Configuration procedure
Create VLANs, and assign corresponding ports to the VLANs. Configure the IP address of each
1.
VLAN interface as shown in
Configure a track entry on Switch A.
2.
# Configure track entry 1, and associate it with the physical status of the uplink interface VLAN-interface
3.
[SwitchA] track 1 interface vlan-interface 3
Configure VRRP on Switch A.
3.
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the priority of Switch A in VRRP group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
# Configure the device to monitor track entry 1, and specify the priority decrement as 30.
[SwitchA-Vlan-interface2] vrrp vrid 1 track 1 reduced 30
Configure VRRP on Switch B.
4.
<SwitchB> system-view
[SwitchB] interface vlan-interface 2
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
Verify the configuration.
5.
After configuration, ping Host B on Host A, and you can see that Host B is reachable. Use the display
vrrp command to view the configuration result.
# Display detailed information about VRRP group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Figure 50. (Details not shown)
: Standard
: Virtual MAC
186