SeeMeCNC Rostock Max v3 Setup Manual page 4

Rostock Max v3 RTP User Guide
Step 2 — Remove the Shrink Wrap
Step 3 — Inverting the Arms
The arms have been inverted to prevent the hot end nozzle from striking the glass print surface

during shipping. To invert the arms from shipping position to printing position
Place your hand on ONE of the carriages and slowly move this carriage upward toward the top

of the printer.
Next select one of the two remaining carriages and repeat.

Do the same operation with the final carriage.

© 2017
Remove the printer from the

shipping container if you have not
done so already. You can do this by
lifting the printer straight up out of
the container. The best place the
grab the machine is by the vertical
rails (silver aluminum rails).
Carefully remove all shrink wrap

from the frame of the printer. Be
careful not to cut the machine (or
yourself) if you are using a knife.

seemecnc.dozuki.com
Don't worry about removing the
shrink wrap from the bed. We will
get to that in future steps.
Page 4 of 11