Igmp Snooping Commands - Cisco 3032 Software Configuration Manual

IGMP Snooping Commands

IGMP Snooping Commands
Unsupported Global Configuration Commands
ip igmp snooping tcn
Interface Commands
Unsupported Privileged EXEC Commands
show interfaces [interface-id | vlan vlan-id] [crb | fair-queue | irb | mac-accounting | precedence | irb
| random-detect | rate-limit | shape]
Unsupported Global Configuration Commands
interface tunnel
Unsupported Interface Configuration Commands
transmit-interface type number
IP Multicast Routing
Unsupported Privileged EXEC Commands
clear ip rtp header-compression [type number]
The debug ip packet command displays packets received by the switch CPU. It does not display packets
that are hardware-switched.
The debug ip mcache command affects packets received by the switch CPU. It does not display packets
that are hardware-switched.
The debug ip mpacket [detail] [access-list-number [group-name-or-address] command affects only
packets received by the switch CPU. Because most multicast packets are hardware-switched, use this
command only when you know that the route will forward the packet to the CPU.
debug ip pim atm
show frame-relay ip rtp header-compression [interface type number]
The show ip mcache command displays entries in the cache for those packets that are sent to the switch
CPU. Because most multicast packets are switched in hardware without CPU involvement, you can use
this command, but multicast packet information is not displayed.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
C-6
Appendix C Unsupported Commands in Cisco IOS Release 12.2(52)SE
OL-12247-04