Table of Contents
Advertisement
Cable Cubby 650 UT • Installation Guide (Continued)
Installing Retractors
Follow the steps below to install Retractors. For horizontal or angular Retractor mounting, see the information below at right, then
follow the steps below.
2
Insert the included pin through the
Retractor mounting hole on the side
of the Retractor assembly bracket.
1
Insert Retractors into
the Retractor bracket.
Alternative Retractor Configuration for Cable Cubby 650 UT
Optional Double Retractor bracket mounting:
Install brackets as shown at right. Two double
Retractor brackets can mount up to four
Retractors.
Cable Cubby 650UT
Side View
6
3
Secure the clip
to the pin.
4
Secure the locking screw
on each Retractor. Do not
overtighten.
Horizontal Mounting
Remove two enclosure screws
Remove two enclosure screws
(one on each side) from this position.
(one on each side) from this position.
Then, mount the Retractors as shown
Then, mount the Retractors as shown
at left.
at left.
See the Cable Retractor Setup Guide, available on the
Extron website, for additional steps.
Angular Mounting
Remove the enclosure screws as shown above, then follow
this step:
Move the cable release assembly upward until
Move the cable release assembly upward until
the angular mounting hole is visible. Reinstall the
the angular mounting hole is visible. Reinstall the
enclosure screws in this hole (both sides).
enclosure screws in this hole (both sides).
2
Secure the brackets using four of
the provided pan-head mounting
screws with star washers. Tighten
the screws using a screwdriver.
1
Insert the brackets as shown.
The bracket may be installed on
the left or right side of the enclosure
e
and at the lowest height.
Cable Release
Cable Release
Assembly
Assembly
Advertisement
Table of Contents
