Vega POINTRAC 31 Operating Instructions Manual page 30

6 Set up with the display and adjustment module
Additional adjustments/
PIN
Additional adjustments/
Date time
Additional adjustments
- Reset
30
Additional settings
In this menu item, the PIN is permanently activated/deactivated. Thus
you protect the sensor data against unauthorized access and unin-
tended changes. The default setting of the PIN is 0000.
This parameter is described in the operating instructions manual
"Display and adjustment module".
In this menu item you can set the actual date and time.
This parameter is described in the operating instructions manual
"Display and adjustment module".
When a reset is carried out, all settings (with only a few exceptions)
are reset. The exceptions are: PIN, language, SIL and HART mode.
The following reset functions are available:
Basic adjustments: Resetting of the parameter adjustmetns to
default values at the time of shipment. Order-specific settings will be
deleted.
Default settings: Resetting of the parameter adjustment like under
"Basic adjustment". In addition, special parameters will be reset to
default values. Order-specific settings will not be deleted.
Peak values measured value: Resetting of the parameter adjust-
ments in the menu item "Setup" to the default values of the respective
instrument. Order-specific settings remain but are not taken over into
the current parameters.
Peak values temperature: Resetting of the measured min. and max.
temperatures to the actual measured value.
The following table shows the default values of the instrument. The
values apply for the application "Level". First of all you have to select
the application.
Depending on the instrument version, not all menu items may be
available or they may be differently assigned:
POINTRAC 31 • 8/16 mA/HART - four-wire