Vega POINTRAC 31 Operating Instructions Manual page 31

Additional adjustments/
HART mode
Additional adjustments/
Copy instrument settings
Info
POINTRAC 31 • 8/16 mA/HART - four-wire
Menu Menu item
Adjustment Measurement
loop name
Isotope
Applications
Adjustment mode Single point adjustment
Adjustment - un-
covered
Adjustment - cov-
ered
Delta I
Background ra-
diation
Temperature unit
Damping
Current output
mode
X-ray alarm
Mode - Relay
Block operation
Display Language
Displayed value
Additional settings Temperature unit
HART mode
With this function you can select the mode.
The sensor offers the HART modes standard and multidrop.
If the measured value is outputted via the 4 ... 20 mA output, you
must not switch over to HART Multidrop.
The mode 'Standard', with fixed address 0 (factory setting), means
output of the measured value as 8/16 mA signal.
This parameter is described in the operating instructions manual
"Display and adjustment module".
With this function
•
Load parameter adjustment data from the sensor into the display
and adjustment module
•
Write parameter adjustment data from the display and adjustment
module into the sensor
This parameter is described in the operating instructions manual
"Display and adjustment module".
Info
In this menu you will find the following menu items:
6 Set up with the display and adjustment module
Default value
Sensor
Cs-137
Limit level
90000 ct/s
9000 ct/s
only with two-point adjustment
90 %
0 ct/s
°C
Is calculated automatically by the in-
strument
8/16 mA, < 3.6 mA
Modulated measuring current
Overfill protection
Released
Selected language
Pulse rate
°C
Standard
31