Replacing The Monitor With A New One - NAMCO TIME CRISIS 2 Operation Manual

( 2 )

Replacing the monitor with a new one

represents something that must not be touched.
them from getting an electric shock, accident. or inbury
. Some parts in the monitor have voltages of more thlan
shock. Therefore do not touch anything inside the monitor.
. The anode cap, anode lead, and fiyback
any of them, because i t might give you an electric shock.
l
with a new one.
Angle
l
The circuitry is divided into a primary and a secondary, which are electrically insulated from
m o n i t o r
each other. Do not touch the primary. Do not touch the primary and secondary at the same time (thus
short-circuiting them). This might cause an electric shock or breakdown, thus being dangerous.
l
Primary (main PCE)
If solder dust. paper dust, or other foreign matter is found inside the monitor, turn off the power switch
the monitor shows any disorder, turn
The monitor weighs about 40kg. This work must be conducted by at least Iwo
and 1o
20,000 bolts and might give you an electric
retain high voltage after power-off. Never touch
e cap approx. 29,000V
Anode lead approx. 29,OOOV
Focus lead approx. 10
transformer
approx. 29,000v
e cap approx. 29,OOOV
Anode approx. 29,OOOV
lead
Focus lead approx. 10,OOOV
transformer
Secondary (charsis sheet panel, CRT, etc.)
Primary (main PCB)
off the power switch immediately and contact your dealer.
8.
protect the electric circuit from damage.
approx. 1o.ooov
workers.
MAINTENANCE