How To Change The Settings In Factory Mode; Submenu Table In Factory Mode - Citizen CL-E720DT Technical Manual

(3) How to change the settings in Factory mode

• In Factory mode, DO NOT change the factory-set values unless you need to
change them, since there are essential items related to printing accuracy, etc.
• Do not turn OFF the power of the printer until you finish the adjustment. If it is
turned OFF, you need to repeat the adjustment from the beginning.
• The value adjusted here is retained until you change it with the same
procedure. Note that, even if you perform initialization by selecting "Test
Mode" main menu, "Factory Default" submenu and "Yes" in that order, the
changed value here does not return to the initial value set at the factory.

(3-1) Submenu table in Factory mode

The following table shows the submenus of "Factory Setup" main menu.
For the factory submenu operation, refer to the next item
mode".
*1 "[Factory Mode Settings Menu name]" in "Submenu Name" column shows the name
that will be printed in "Factory Mode Settings". (Refer to
Factory Mode Settings
*2 "+" shows that the object moves forward/rightward electrically, while "-" shows that it
moves backward/leftward electrically. 8 dots correspond to 1 mm (203 dots correspond
to 1 inch).
Submenu Name
[Factory Mode Settings
Menu name]
Init Thru Sen
Init Refl Sen
Through Pos
[Through Sensor Position]
Reflect Pos
[Reflect Sensor Position]
Mach Tear Pos
[Machine Tear Position]
Mach Cut Pos
[Machine Cut Position]
Mach Peel Pos
[Machine Peel Position]
menus".)
Adjustable Value
(Default Value)
Performs calibration of the transparent sensor
sensitivity. For details, refer to
sensitivity adjustment (Factory
Chapter 3.
Performs calibration of the reflective sensor
sensitivity). For details, refer to
sensitivity adjustment (Factory
Chapter 3.
-256 to +256 dot Electrically shifts the position of transparent
(+000 dot) sensor back and forth.
(-32 to +32 mm, -1.26 to +1.26 inches)
-256 to +256 dot Electrically shifts the position of reflective sensor
(+000 dot) back and forth.
(-32 to +32 mm, -1.26 to +1.26 inches)
-256 to +256 dot Electrically shifts the tear off position back and
(+000 dot) forth. (-32 to +32 mm, -1.26 to +1.26 inches)
-256 to +256dot Electrically shifts the cut position back and forth.
(+000 dot) (-32 to +32 mm, -1.26 to +1.26 inches)
(Option)
-256 to +256dot Electrically shifts the peel position back and
(+000 dot) forth. (-32 to +32 mm, -1.26 to +1.26 inches)
(Option)
2-47
Chapter 2 Operating Principles
2-3.
Operation Panel
"(3-2) Setting submenu in Factory
"2-3-3(2) How to print the
Description
"3-7(2) Sensor
mode)" in
"3-7(2) Sensor
mode)" in
CL-E720DT