Data Flow And Operation Options - Data Translation DT9837A User Manual

Data Flow and Operation Options

DT9837 Series Modules
Single-Value Operation Support
SupportsSingleValue
Simultaneous Single-Value Output Operations
SupportsSetSingleValues
Continuous Operation Support
SupportsContinuous
Continuous Operation until Trigger
SupportsContinuousPreTrigger
Continuous Operation before & after Trigger
SupportsContinuousPrePostTrigger
Waveform Operations Using FIFO Only
SupportsWaveformModeOnly
Simultaneous Start List Support
SupportsSimultaneousStart
Supports Programmable Synchronization Modes
SupportsSynchronization
Synchronization Modes
SynchronizationMode
Interrupt Support
SupportsInterruptOnChange
FIFO Size, in samples
FifoSize
Muting and Unmuting the Output Voltage
SupportsMute
Auto-Calibrate Support
SupportsAutoCalibrate
a. The D/A subsystem is not supported by the DT9837B module.
b. To perform a single value analog output operation, ensure that no analog input operations are running or an error will be
reported.
c. For the DT9837, if you want to output data from the analog output channel while acquiring analog input data, ensure that you
set up and start the analog output operation before starting the analog input operation, or an error will be reported.
d. The DT9837A and DT9837C modules support continuous analog output operations in addition to waveform mode.
e. The DT9837A and DT9837C modules support the ability to start continuous A/D and continuous D/A operations
simultaneously.
f. The DT9837A and DT9837 C modules have an input FIFO of 2 kSamples; the DT9837B has an input FIFO of 4 kSamples; and
the DT9837 does not use an input FIFO.
g. The DT9837B does not have an output FIFO. The output FIFO on the DT9837, DT9837A, and DT9837C is 8 kSamples.
Table 4: Data Flow and Operation Options
A/D
Yes Yes
Yes Yes
Yes
e
Yes Yes
Yes
None, Master,
Slave
2 kSamples or
f
4 kSamples 8 kSamples
Yes
a
D/A DIN DOUT
b
c
d
e
g
Supported Device Driver Capabilities
C/T TACH QUAD
93