Goodman AVPTC42D14 series Installation & Operating Instructions Manual page 5

tubing panel may remain screwed together during this procedure. Remove and retain the seven (7) screws securing
the coil access panel to the cabinet and the six (6) screws securing the blower access panel to the cabinet.
2. Slide the coil assembly out using the drain pan to pull the assembly from the cabinet.
NOTE: DO NOT USE MANIFOLDS OR FLOWRATOR TO PULL THE COIL ASSEMBLY OUT. FAILURE TO DO SO
MAY RESULT IN BRAZE JOINT DAMAGE AND LEAKS.
3. Removal of the center support is required on units with 21" wide cabinet. Remove and retain the two (2) screws that
secure the center support to the cabinet. Remove the center support.
4. Using the drain pan to hold the coil assembly, slide the coil assembly back into the cabinet on the downflow brackets as
shown in Figure 8.
UPFLOW
Figure 2
HORIZONTAL LEFT
NOTE: If removing only the coil access panel from the unit, the filter access panel must be removed first. Failure to do so
may result in panel damage.
Figure 4
DOWNFLOW
HORIZONTAL RIGHT
5
Figure 3
Figure 5