Goodman ARUF Series Installation & Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Goodman Manuals
  4. Air Handlers
  5. ARUF Series
  6. Installation & operating instructions manual

Goodman ARUF Series Installation & Operating Instructions Manual

Hide thumbs Also See for ARUF Series:
Table of Contents

Advertisement

Quick Links

INSTALLATION & OPERATING
INSTRUCTIONS FOR
®
ARUF, ARPF, ADPF, AEPF
C
US
SERIES AIR HANDLER
Made in the USA by:
Goodman Manufacturing Company, L.P.
IO-286A
2550 North Loop West, Suite 400 - Houston, Texas 77092
5/06
www.goodmanmfg.com or www.amana-hac.com
© 2004-2006 Goodman Manufacturing Company, L.P.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ARUF Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Goodman ARUF Series

Summary of Contents for Goodman ARUF Series

  • Page 1 INSTRUCTIONS FOR ® ARUF, ARPF, ADPF, AEPF SERIES AIR HANDLER Made in the USA by: Goodman Manufacturing Company, L.P. IO-286A 2550 North Loop West, Suite 400 - Houston, Texas 77092 5/06 www.goodmanmfg.com or www.amana-hac.com © 2004-2006 Goodman Manufacturing Company, L.P.

  • Page 2: Table Of Contents

    For the location of your nearest distributor consult the white business pages, the yellow page section of the local telephone book, or contact the following: SERVICE PARTS DEPARTMENT GOODMAN MANUFACTURING COMPANY, L.P. 2550 NORTH LOOP WEST, SUITE 400 HOUSTON, TEXAS 77092 (713) 861 – 2500...

  • Page 3: Warnings

    DO NOT CONNECT TO OR USE ANY DEVICE THAT IS Carbon monoxide producing devices (such as an automobile, space NOT DESIGN CERTIFIED BY GOODMAN FOR USE WITH heater, gas water heater, etc.) should not be operated in enclosed areas such as unventilated garages, utility rooms or parking areas because of THIS UNIT.

  • Page 4: Model Identification

    Using the table “Model Identification” section, check the manual and local/state codes An ARI certified rating is equipment model number to ensure the unit is appropriately available for many combinations when matched with a sized for the condenser unit. Goodman or Amana® brand condenser or heat pump.

  • Page 5: Electric Heat

    If an incorrect unit is supplied, it must not be installed and HEAT KIT NOMINAL kW it is to be returned to the supplier. The manufacturer assumes no responsibility for the installation of incorrectly delivered units. The evaporator coil contains a high-pressure inert gas 1000 holding charge.

  • Page 6: Ductwork

    sturdy, non-porous material. In installations that may lead WARNING to physical damage (i.e. a garage) it is advised to install a protective barrier to prevent such damage. HIGH VOLTAGE!! DISCONNECT ALL POWER BEFORE SERVICING. DUCTWORK MULTIPLE POWER SOURCES MAY BE PRESENT. FAILURE TO DO SO MAY CAUSE PROPERTY DAMAGE, This air handler is designed for a complete supply and return PERSONAL INJURY, OR DEATH.

  • Page 7: Refrigerant Lines

    See the Goodman piston Air Handler With Heat Kits Containing a Circuit Breaker. kit chart if necessary. Consult your local distributor for the HKR models with a “C”...

  • Page 8: Aepf Motor Orientation

    1. Loosen the 13/16 nut 1 TURN ONLY. No pressure loss FRONT VIEW SIDE VIEW indicates possible leak. 2. Remove the nut and discard the cap. 3. Remove the check piston to verify it is correct. See piston kit chart in instructions. 4.

  • Page 9: Conversion To Horizontal

    Return Air Side of Unit Access Panel Rear Channel WRAPPER Bracket Zee Coil INSULATION Support Bracket JACKET Coil Retaining Bracket ZEE COIL SUPPORT Tie Bracket WRAPPER STIFFENER NOTE: The filter provision is not applicable in THIS downflow application. DRAIN PAN INSULATION KIT Figure 4 BLOWER...

  • Page 10: Condensate Removal

    2. Remove the “J” shaped bracket that retains the Drain evaporator coil. Connection 3. Remove the flowrater from the lower left side access panel and slide out the evaporator coil and horizontal Air Handler 2" MIN. drain pan. 4. Remove the gasket from the horizontal pan drain POSITIVE LIQUID SEAL REQUIRED 3"...
  • Page 11 The AEPF product uses a General Electric ECM motor. Switch Switch Nominal Cooling This motor provides many features not available on the Model Tonnage traditional PSC motor. These features include: 2 ½ 1100 • Improved Efficiency AEPF1830 • Constant CFM 1 ½...

  • Page 12: Thermostat Wiring Diagrams

    Thermostat Wiring Use thermostat wiring diagram Figures 9 thru 12 and those provided with the thermostat when making these connections. NOTE: DO NOT USE THESE DIAGRAMS FOR AEPF MODELS. SEE SUPPLEMENTAL INSTALLATION AND OPERATING INSTRUCTIONS FOR AEPF MODELS. ROOM THERMOSTAT #18 GA.
  • Page 13 FIGURE 11 ARUF/ARPF/ADPF 18-60 10 KW & BELOW TYPICAL H/P HEAT PUMP #18 GA. 7 WIRE ROOM THERMOSTAT AR UNIT O Y R Y O C G R E GREEN NOTE WHITE BLUE #18 GA. 5 WIRE (OPTIONAL) OUTDOOR THERMOSTAT CLOSE ON TEMPERATURE FALL #18 GA.

  • Page 14: Thermostats

    Unit is elevated when installed in a garage or where thermostat as shown in Figures 12 and 13. flammable vapors may be present. Goodman part number CHT18-60 is a single-stage cool and • Unit is protected from vehicular or other physical single-stage heat thermostat.

This manual is also suitable for:

Arpf seriesAdpf seriesAepf series

Table of Contents

Save PDF