Goodman AVPTC42D14 series Installation & Operating Instructions Manual page 15

19 kW or
21 kW* or
20 kW
25 kW*
OFF ON OFF
S9 S9
S10 S10
S11 S11
NOTE: Upon start up in communicating mode the circuit board may display an "Ec" error. This is an indication that the dip
switches on the control board need to be configured in accordance with the Electric Heating Airflow Table. Configuring
the dip switches and resetting power to the unit will clear the error code.
Within the thermostat user menu, CTK0* communicating thermostat will display 20 kW for OFF-OFF-ON dip switch
selection and 21 kW for OFF-OFF-OFF dip switch selection.
• Profile A provides only an OFF delay of one (1) minute
at 100% of the cooling demand airflow.
• Profile B ramps up to full cooling demand airflow by first
stepping up to 50% of the full demand for 30 seconds.
The motor then ramps to 100% of the required airflow.
A one (1) minute OFF delay at 100% of the cooling air-
flow.
• Profile C ramps up to 82% of the full cooling demand
airflow and operates there for approximately 7 1/2 min-
utes. The motor then steps up to the full demand air-
flow. Profile C also has a one (1) minute 100% OFF de-
lay.
• Profile D ramps up to 50% of the demand for 1/2 minute,
then ramps to 82% of the full cooling demand airflow
and operates there for approximately 7 1/2 minutes. The
motor then steps up to the full demand airflow. Profile D
has a 1/2 minute at 50% airflow OFF delay.
7. If an electric heater kit has been installed, determine the heater kilo-
watt (kW) rating. Using the Electric Heat Airflow table on page 16,
set dip switches 9, 10, and 11 for the installed heater. The adjust
setting (already established by the cooling speed selection) also
applies to the electric heater kit airflow. Thus, the electric heater
airflow is adjusted by the same amount. This does not apply to sys-
tems setup with a communicating thermostat. See Set-Up section
in the A H A
IR ANDLER
lected CFM by counting the green CFM LED blinks.
15 kW
ON OFF ON
S9 S9
S10 S10
S11 S11
Electric Heating Airflow (*indicates factory setting)
F M on page 22. Verify se-
DVANCED EATURES ENU
10 kW 8 kW
OFF ON OFF ON
S9
S10
S11
Figure 25
OFF
50% CFM
OFF
1/2 min
OFF
OFF
15
6 kW 5 kW
OFF ON OFF
S9 S9
S10 S10
S11 S11
100% CFM
Figure 26
100% CFM
Figure 27
100% CFM
Figure 28
Figure 29
Tap A* Tap B Tap C
OFF ON OFF ON OFF
S5 S5
S5
S6 S6 S6
Figure 30
Dip Switches - Cooling Airflow Ramping Profiles
3 kW
ON OFF ON
S9
S10
S11
100% CFM
OFF
1 min
100% CFM
OFF
1 min
OFF
OFF
Tap D
ON OFF ON
S5
S6