Removing The Control Head - Tait TM8250 User Manual

body. The numbers in the diagram on the previous page
refer to the numbered steps below.
1. Plug the control head loom onto the control
2. Insert the bottom edge of the control head onto the

Removing the control head

reduces environmental protection.
1. On the underside of the radio, insert a flat-bladed screw-
2. Use the screwdriver to lift the control head off the chassis
head connector.
two clips in the front of the radio chassis, then snap
into place.
Important: During this procedure, take care that the
chassis seal is not damaged. Damage to this seal
driver between the control head and the radio chassis
seal, in either position
Note: Insertion points
on the radio chassis by a dot-dash-dot
–
pattern (• •).
clip, then repeat in the other position.
The control head can now be removed from the radio body.
1
or .
2
1
and
2
1
Radio Installation 35
2
are indicated