Fuel Hopper Cleaning - LASIAN AUDAX 6 KW User And Installation Manual

If the glass breaks during the cleaning operations by accident, avoid turning on the stove and
replace the glass only with an original spare. For replacement, contact a Technical Assistance
Center.

9.9 FUEL HOPPER CLEANING

The sawdust detached of the pellet when we load it and during the operation of the stove, it stays stored in the
bottom of the hopper.
If this sawdust accumulate in excess could cause problems in the operation of the stove, so it is necessary to
remove it periodically.
So we must let spent all pellet in the hopper or speed up almost to the end, and with a vacuum cleaner from the
top door which give access to the hopper, remove all particles accumulated at the bottom.
Never remove the protection grille which is inside the hopper.
9.10 ANNUAL INSPECTION
We call "Annual Inspection" to an extraordinary maintenance, in which a complete and thorough cleaning of the
stove is made, as well as a checking of the operation of all devices of the stove and the state of wear elements.
It should also clean the chimney (unload installation) to ensure a proper functioning of stove-chimney as a whole,
and perform the necessary adjustments.
The frequency with it must be performed is indicated in the maintenance table of paragraph 9.1.
The Annual Inspection can only carried out for qualified staff or an authorized TAS.
The Annual Inspection is essential to ensure a proper functioning of the stove, if it is not carried
out, the problems that occur during the functioning of the stove, will not be covered under
warranty.
COD. 83119L.01EN
45
09//2016