LASIAN AUDAX 6 KW User And Installation Manual page 34

4) In the moment of turning on the stove it can appear a message of error. It is possible the error that has
appeared is the error "Er11", to indicate that time and date are not updated. In any case, check the section
"8- PROBLEMS, MESSAGES AND ALARMS" to know how to act, as while it appear some error on the
screen we could not initiate the stove.
5) Before the first power-up of the stove, it is necessary to fill the auger of fuel by the user function "Pellet
manual load". To do that, follow the instructions indicated in the section 6.1.3 and interrupt the load when
the pellet starts falling into the burner continuously. Empty the burner and and then, put it again in the
same position to turn on the stove.
6) To turn on the stove, push the button
the lower right side the working power that has been selected (see the section 6.1.2).
Working power
At this moment, the control panel carries out a check-up of the stove "Chec" in order to make verification.
If during the check-up, the control panel detects any defect, the stove will not start-up and it will appear a
message of error. If everything is correct, the stove will power-up.
In the first power-up it is important that the temperature of the stove increases gradually, so
during the first 12 hours of working do not reach the power 3.
During the first power-up, fume can be seen expelled by the stove in the room, but actually they
are vapours from the varnish of the stove, and after some hours it disappears. It is advisable keep
the room aired during this time.
COD. 83119L.01EN
for some seconds until you hear a whistle, and it will appear on
Screen during the start-up
34
Hour
Room Temperature
Stove state
Room temperature
09//2016