Cleaning And Maintenance - LASIAN AUDAX 6 KW User And Installation Manual

ALARM
DESCRIPTION
CODE
Excessive airflow
Er42
during the "Check Up"
With the help of this alarms table, the user should be able to identify the cause of the
alarm.
Once the cause has been detected and corrected, to turn on the stove again it is
necessary to reset that alarm.
RESET OF THE ALARMS:




If after have followed every single step of how to reset the alarms and you do not get to reset
the stove, or if every time you try to start again the stove the alarm keeps appearing, inform the
Technical Service.

9. CLEANING AND MAINTENANCE

For a proper functioning of the stove it is essential to carry out certain maintenance tasks, which often depend
primarily on the operating hours and the fuel quality. Some of them must be carried out daily, whereas others just
make them once a season.
The user is responsible for carrying out the cleaning and maintenance tasks, some of these tasks have to be
carried out directly by the user and others contacting a qualified staff or authorized TAS.
When the message "CLr" is displayed on the screen (Ordinary Maintenance), the user must carry out or make sure
that the maintenance tasks marked with an asterisk (*) have been carried out recently, check paragraph "9.1-
MAINTENANCE TABLE".
When the message "Serv" is displayed on the screen (Extraordinary Maintenance), the user should contact a
qualified staff or authorized TAS in order to carry out, if it has not been performed recently, the maintenance tasks
marked with (**), check paragraph "9.1- MAINTENANCE TABLE".
COD. 83119L.01EN
"Sond")
POSSIBLE CAUSE
It may appear if we had an excessive
draught in the chimney, or if we are
forcing the air inlet for the pellet.
The pressure switch is damaged, and in
this case, it may appear with the
message "Sond".
When an alarm is produced, the stove starts turning off.
The alarm cannot be reset until the stove is completely off.
Once the stove is off you have to wait until in the display on top appears "Alt" and push
for some seconds the button
Once the alarm has been reset, it is advisable to turn off the stove for some seconds
pushing the back switch.
Check and correct the installation.
In case that this alarm appears often,
or in case you do not get to reset it,
inform
Service.
Inform
Service
to reset the alarm that is active.
40
SOLUTION
the Technical Assistance
the Technical Assistance
09//2016