Heat Exchanger Cleaning - LASIAN AUDAX 6 KW User And Installation Manual

With an ash vacuum, vacuum the ash accumulated inside the chamber, remove the brazier and control that
the holes in it are clear. It is also necessary to clean the brazier support vacuuming the existing ash.
Normally, you need to do this cleaning every 8-12 hours of operation of the stove, but with
a pellet whose quality or ash content is not optimal, it may need done more often.
Before switching on the stove, check that the brazier is put back towards the pipe of the ignition
resistor.

9. HEAT EXCHANGER CLEANING

It is a very simple operation and it does not require any tool, but it ensures that we have a good heat exchange
from the stove to the ambient air.
It is done when the stove is cold, and it would be desirable to do before every start, or at least once a day.
To perform this cleaning we have on the front of the stove one or two knobs (depending on the stove model).
Moving them backwards and forwards, we move a grill that cleans the heat exchanger, removing the combustion
waste and ensuring a maximum performance.
The 8 kW model has two knobs (see Fig. 9.3), the 10 kW model has one (see Fig. 9.4), whereas the 12 kW model
has two knobs but on the top of the stove. The 6 kW model do not have this system.
9.5 COMBUSTION CHAMBER CLEANING
Usually once a year (preferably at the beginning of the season), the extraordinary cleaning of the combustion
chamber must be performed to allow a correct operation of the stove. The frequency of this operation depends on
the type of fuel used and the frequency of use. To perform this cleaning it is advisable to contact a Technical
Assistance Center.
COD. 83119L.01EN
Fig. 9.3
43
Fig. 9.4
09//2016