Reading Parameters
Reading Parameters
Point the reader at the target and press the Scan button to
enable the aiming system and the illuminator (red beam) to
decode the barcode label. The aiming system will briefly
switch off during the acquisition time and, if no code is
decoded, it will switch on again before the next acquisition.
The illuminator will remain on until the symbol is decoded.
As you read code symbols, adjust the distance at which you
are holding the reader.
Aiming System
A number of options for customizing control of the Aiming
System are available. See the PRG for more information and
programming bar codes.
Good Read Green Spot Duration
Successful reading can be signaled by a good read green spot.
Use the bar codes below to specify the duration of the good
read pointer beam after a good read.
GOOD READ GREEN SPOT DURATION
ENTER/EXIT PROGRAMMING MODE
Green Spot Duration = Disable (Green Spot is Off)
Green Spot Duration = Short (300 msec)
24
RIDA™ DBT6400