Introduction; Parts List; Product Specifications; Cable Specifications - HID VertXHID V2000 Quick Installation Manual

VertX V2000 (CS) Quick Installation Guide

Introduction

VertX™ CS is the first family of access controllers designed specifically for alarm dealers for direct
connection to central stations. Because it was designed with central station in mind, VertX CS works with
software from leading central station automation providers, including Bold Technologies, DICE and
GE MAS.
The V2000 is designed to control two sets of door devices (such as two-doors, two-readers, associated
contacts and relays) as well as manage communications with the central station automated software.

Parts List

Description
VertX™ V2000 Reader Interface/Access Controller
Note: The V2000 controller has a plastic base and is covered
with a Plastic or Mylar cover.
- Lithium Battery
- Mounting screws
- 2.2K EOL resistors
- Quick Installation Guide
- Installation Wiring Diagram Example

Product Specifications

Description
Power Supply
Maximum current at 12VDC per V2000
Average operating current at 12VDC
Operating temperature range
Humidity

Cable Specifications

Cable Type
Input Circuits * 500 feet (150 m)
Output Circuits * 500 feet (150 m)
500 feet (150 m) to reader
Wiegand
Ethernet 328 feet (100 m)
Power Supply
----
+12 VDC IN
* Minimum wire gauge depends on cable length and current requirements.
August 2005
12-16VDC
1 Amp
625 mA (with two R40 iCLASS Readers)
32°-122°F (0°-50°C)
5% to 95% non-condensing
Length
2-conductor, shielded, using ALPHA 1292C (22AWG) or Alpha 2421C
(18AWG), or equivalent.
2-conductor, using ALPHA 1172C (22AWG) or Alpha 1897C (18AWG), or
equivalent.
ALPHA 1299C, 22AWG, 9-conductor, stranded, overall shield.
Fewer conductors needed if all control lines are not used.
Cat5, Cat5E, and Cat6
Refer to your Power Supply Installation Guide.
2005 © HID Corporation. All rights reserved.
Quantity
1
1
4
8
1
1
Specification
Specification
Page 3 of 23