HID VertXHID V2000 Quick Installation Manual page 8

VertX V2000 (CS) Quick Installation Guide
Output
number
10
11
12
5. Input Connections – Input connections are used for a combination of specific functions such
as Request-to-Exit (REX), Door monitor, etc. They can also be used as general purpose
monitoring. Connect one side of the switch or contact to the + (plus) lead and the other to the
– (minus) lead. The following table shows where the inputs are located among the different
VertX units. Pin numbers shown on the cover use the convention +/–.
The default REX switch configuration is normally open (NO) unsupervised (no EOL resistors),
while the default door switch (DS) configuration is Normally Closed (NC) unsupervised (no
EOL resistors). All other input points are defaulted for NO switches and are unsupervised (no
EOL resistors).
Any input can be configured as a supervised input. They can be configured for resistors of 1K
– 6K Ohm. The setup of supervised inputs should be done during configuration of the VertX
units via the central station automation software (host) or by using the Calibrate Input tool, see
section 4.1 Calibrate Input.
Example: Input 1, V1000 is: P14 Pin1 is + and Pin 2 is -.
All default inputs will be:
Input
V2000
number
P2 Pins 1/2
1
Door Monitor
P2 Pins 3/4
2
REX input
P5 Pins 4/3
3
Door Monitor
P5 Pins 2/1
4
Rex Input
P7 Pins 8/7
5
Tamper
P7 Pins 6/5
6
AC Fail
August 2005
V2000 V1000
V1000
P14 Pins 1/2
P11 Pins 4/3
P7 Pins 8/7
Tamper
P7 Pins 6/5
AC Fail
P7 Pins 4/3
Batt Fail
2005 © HID Corporation. All rights reserved.
V100 V200
Supervised inputs can be configured for:
V100 V200
P2 Pins 1/2
P1 Pins 1/2
Door Monitor
P2 Pins 3/4
P1 Pins 3/4
REX input
P5 Pins 4/3
P1 Pins 5/6
Door Monitor
P5 Pins 2/1
P1 Pins 7/8
Rex Input
P7 Pins 8/7 P1 Pins 9/10
Tamper
P7 Pins 6/5 P2 Pins 1/2
AC Fail
V300
P5 Pins 9/8/7
P5 Pins 6/5/4
P5 Pins 3/2/1
V300
P6 Pins 2/1
P3 Pins 1/2
P7 Pins 8/7
Tamper
P7 Pins 6/5
AC Fail
P7 Pins 4/3
Batt Fail
Page 8 of 23