HID VertXHID V2000 Quick Installation Manual page 21

VertX V2000 (CS) Quick Installation Guide
3.6.1.4 /mnt/flash/TaskConfig/CommCfg
From the Edit Configuration Files screen, edit the
1. Select
2. Click Edit File. The Edit File window will display.
3. Enter the appropriate configuration data, see the Pre-Installation Checklist – Ref #4,
23, for the VertX controller to communicate to the Host.
Example:
#
# commtask configuration parameters
# ------------------------------------------------------
# Connect to host on startup (1=>yes)
connect_on_start 1
# If contacted by a host, maintain connection without callback (1=>yes)
maintain_host_connection 0
# Call the host machine on this port
connection_port 4070
# Listen on this port for host connection requests
listen_port 4050
# If a connect attempt fails, wait this interval (~secs)
# before attempting to connect to the next host in CommHosts
reconnect_interval 15
# If no messages are received from the host within this interval (~min)
# then disconnect. (timeout = 0 => no timeout, continuous connection)
timeout 0
# Encrypt host communications (0=no, 1=yes)
use_encryption 0
# If a response to a host request is not received within this time (~secs),
# then disconnect.
message_response_time 20
3.6.1.5 /mnt/flash/TaskConfig/CommHosts
From the Edit Configuration Files screen, edit the
communicate with the central station automation software (host).
This is the last configuration file requiring edits for Ethernet setup.
1. Select
2. Click Edit File. The Edit File window will display.
August 2005
/mnt/flash/TaskConfig/CommCfg
/mnt/flash/TaskConfig/CommHost
2005 © HID Corporation. All rights reserved.
/mnt/flash/TaskConfig/CommCfg
from the list.
/mnt/flash/TaskConfig/CommHost
from the list.
configuration file.
page
configuration file to
Page 21 of 23