Table of Contents
Advertisement
VertX V2000 (CS) Quick Installation Guide
# then disconnect.
message_response_time 20
3.5.1.2
/mnt/flash/TaskConfig/CommHosts
/mnt/flash/TaskConfig/CommHost
Finally, edit the
station automation software (host).
This is the last configuration file requiring edits for Ethernet setup.
1. From the Edit Configuration Files screen, select
the list.
2. Click Edit File. The Edit File window will display.
For Static TCP/IP configuration edit the first two lines (lines 1 and 2 shown in the example).
10.19.4.130
Change "
host(s) in which you are working. See the Pre-Installation Checklist – Ref #5,
Example of Ethernet primary only:
# commtask connection file
# cmid WaitTime MaxPings Username Script IPAddress(or Hostname) CommChannel(1-3)
1
1
2
*
2
1
2
*
#3
20
4
router1
#4
20
4
modem1
3.6
Static TCP/IP Addressing
The following outlines hardware requirements and provides a detailed configuration procedure to aid you in
connecting to the V2000 through the static TCP/IP addressing configuration only.
See sections 3.2, 3.3, and 3.4 for instructions on how to start.
3.6.1
Configuration File Edits
The Setup Host Communication screen will take you to the Edit Configuration Files screen. The
configuration files available for editing will enable TCP/IP Static host communications using the Static TCP/IP
addressing communications method.
Select a file from the list and click Edit File. If you need to clear the selection, click Clear Selection.
While following these instructions edit the circled areas shown.
3.6.1.1
/mnt/flash/etc/conf.d/net.eth0
/mnt/flash/etc/conf.d/net.eth0
First, edit the
1. Select
2. Click Edit File. The Edit File window will display.
Modify the following lines to match the controller's specified configuration.
See the Pre-Installation Checklist – Ref #1,
1. IP (Controller's IP Address).
2. NETMASK (Subnet Mask).
3. Gateway (Network Gateway).
August 2005
VertXProductionTest
" and/or "
*
10.19.4.130
*
VertXProductionTest
Router
10.10.10.2
Modem
10.19.4.131
/mnt/flash/etc/conf.d/net.eth0
page
2005 © HID Corporation. All rights reserved.
configuration file to communicate with the central
/mnt/flash/TaskConfig/CommHost
" to include the IP Address or host name of the
1
1
2
2
configuration file.
from the list.
23.
from
page
23.
Page 19 of 23
Hide quick links:
Advertisement
Table of Contents
