Computer To Vertx Controller Connection; Windows Tcp/Ip Configuration - HID VertXHID V2000 Quick Installation Manual

VertX V2000 (CS) Quick Installation Guide
3.2

Computer to VertX Controller Connection

Note: This step is necessary if you are configuring your communications for DHCP or Static TCP/IP.
3.2.1 Hardware Requirements
The following outlines the hardware requirements for configuring a static TCP/IP connection.
•
Computer with administration rights and a Internet browser, Internet Explorer 5.0 (or greater), or
equivalent.
•
Ethernet cable
•
Optional Hub – Required if primary communication channel is Ethernet.
Connect the computer to the VertX controller using an Ethernet cable.
3.3

Windows TCP/IP Configuration

Prior to proceeding, document your Network Connections settings, in order to change your settings back to
their original configuration.
CAUTION: During the timeframe in which you have changed the TCP/IP settings on your computer,
you will not have access to the Internet or E-mail.
Depending on your operating system, follow one of the listed procedures.
•
Windows XP Computers
•
Windows 2000 Computers
•
August 2005
2005 © HID Corporation. All rights reserved.
Page 11 of 23