Reporting - FLIR E series User Manual

27 – Introduction to building thermography
Produce an image of each anomaly or cluster of anomalies.
Use a software analysis tool to enclose the anomalous area within the image, taking
■
care not to include construction details that are to be excluded.
Calculate the area below the threshold temperature for internal surveys or above
■
the threshold temperature for external surveys. This is the defect area. Some
anomalies that appeared to be defects at the time of the survey may not show defect
areas at this stage.
Add the defect areas from all the images ∑A
■
Calculate the total area of exposed building fabric. This is the surface area of all
■
the walls and roof. It is conventional to use the external surface area. For a simple
shape building this is calculated from overall width, length and height.
A = (2h(L + w)) + (Lw)
t
Identify the critical defect area A
■
0.1% of the total surface area.
A = A /1000
c t
If ∑A < A the building as a whole can be considered to have 'reasonably contin-
■
d c
uous' insulation.
27.4.8.7

Reporting

Reports should certificate a pass/fail result, comply with customers requirements and
as a minimum include the information required by BSEN 13187. The following data
is normally required so that survey can be repeated following remedial action.
Background to the objective and principles of the test.
■
Location, orientation, date and time of survey.
■
A unique identifying reference.
■
Thermographer's name and qualifications.
■
Type of construction.
■
Weather conditions, wind speed and direction, last precipitation, sunshine, degree
■
of cloud cover.
Ambient temperatures inside and outside before, at the beginning of survey and
■
the time of each image. Air temperature and radiant temperature should be
recorded.
Statement of any deviation from relevant test requirements.
■
Equipment used, last calibration date, any knows defects.
■
Name, affiliation and qualifications of tester.
■
Type, extent and position of each observed defect.
■
Results of any supplementary measurements and investigations.
■
Reports should be indexed and archived by thermographers.
■
27.4.8.7.1 Considerations and limitations
The choice between internal and external surveys will depend on:
126
.
d
. Provisionally this is set at one thousandth or
c
Publ. No. T559597 Rev. a554 – ENGLISH (EN) – September 27, 2011