Analog Output; Installing The Analog Output Board - Omega DPF700 User Manual

9.1 INSTALLING THE ANALOG OUTPUT BOARD

Install the analog output board as follows (refer to Figure 9-1):
!
CAUTION: The meter has no power-on switch, so it will be in operation
as soon as you apply power.
!
IMPORTANT: Disconnect the power from the unit before installing this
option board.
1. Hold the analog output card in a horizontal position, with the R37 and R38
potentiometers facing the back of the meter.
2. Line up the P6 connector on the interconnect board with the J6 pin on the main
board. Push down to secure.
3. Line up the J8 pin on the analog output board with the P8 connector on the
interconnect board. Push down to secure.
Figure 9-1. Installing the Analog Output Board
J1
TB1
MAIN BOARD (REF)
TB2
S1
A O
NALOG UTPUT
ANALOG OUTPUT BD
SOLDER SIDE
J8
DISPLAY
BOARD
(REF)
P8
P6
J7
J6
INTERCONNECT
BOARD
(SOLDER SIDE)
9
49