Yamaha MT 10 Owner's Manual page 75

er A by removing the bolts and
quick fastener.
1. Quick fastener
2. Coolant reservoir cover A
3. Bolt
TIP
The quick fastener is removed by push-
ing in the center pin and then pulling the
fastener out.
1
2
6. Remove the coolant reservoir cov-
3
er B and coolant reservoir by re-
moving the bolts.
1
1. Bolt
2. Coolant reservoir cover B
3. Coolant reservoir
4. Coolant reservoir cap
5. Collar
7. Remove the collars and coolant
Periodic maintenance and adjustment
5
4
3
2
8-15
reservoir cap, and then turn the
coolant reservoir upside down to
empty it.
1. Coolant reservoir cap
2. Coolant reservoir
8. After the coolant is completely
drained, thoroughly flush the cool-
ing system with clean tap water.
9. Install the collars, coolant reservoir
and its covers by placing them in
the original position, and then in-
stalling the bolts and quickfastner.
TIP
The quick fastener is installed by push-
ing out the center pin, inserting the fas-
tener into the cover, and then by
pushing the center pin flush with the
1
2
3
1
4
2
5
6
7
8
9
10
11
12