Yamaha MT 10 Owner's Manual page 72

Periodic maintenance and adjustment
1
2
3
4
1. O-ring
5
TIP
6
Make sure that the O-ring is properly
seated.
7
6. Install the new oil filter cartridge
with an oil filter wrench, and then
8 tighten it to the specified torque
with a torque wrench.
9
10
11
12
1
1. Torque wrench
Tightening torque:
Oil filter cartridge:
17 Nm (1.7m·kgf, 12 ft·lbf)
7. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
8. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
1
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE


8-12
Recommended engine oil:
Full synthetic
10W-40, 15W-50
Oil quantity:
Oil change:
3.90 L (4.12 US qt, 3.43 Imp.qt)
With oil filter removal:
4.10 L (4.33 US qt, 3.61 Imp.qt)
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
Make sure that no foreign mate-
rial enters the crankcase.
9. Start the engine, and then let it idle
for several minutes while checking
ECA11621