Yamaha MT 10 Owner's Manual page 37

TIP
If traveling at speeds under 20 km/h (12
mi/h), "– –.–" is displayed.
Average fuel consumption mode
1
1. Average fuel consumption display
This display shows the average fuel
consumption since it was last reset.
The average fuel consumption display
can be set to either "AVE – –.– km/L",
"AVE – –.– L/100 km".

"AVE – –.– km/L": The average
distance that can be traveled on
1.0 L of fuel is shown.

"AVE – –.– L/100 km": The aver-
age amount of fuel necessary to
travel 100 km is shown.
To switch between the average fuel
Instrument and control functions
consumption display settings, push the
"CLOCK" and "RESET" button togeth-
er.
To reset the average fuel consumption,
push the "RESET" button for two sec-
onds.
TIP
After resetting the average fuel con-
sumption, "– –.–" will be shown until the
vehicle has traveled 1 km (0.6 mi).
Display brightness and shift timing
indicator light control mode
1
1. Brightness level display
This mode cycles through five control
functions, allowing you to make the fol-
lowing settings in the order listed be-
5-14
low.

Display brightness:
This function allows you to adjust
the brightness of the displays and
tachometer.

Shift timing indicator light activity
function:
This function allows you to set the
indicator light to on, flash, or off.

Shift timing indicator light activa-
tion:
This function allows you to select
the engine speed at which the indi-
cator light will be activated.

Shift timing indicator light deactiva-
tion:
This function allows you to select
the engine speed at which the indi-
cator light will be deactivated.

Shift timing indicator light bright-
ness:
This function allows you to adjust
the brightness of the shift timing in-
dicator light.
TIP
The brightness level display shows the
brightness level setting.
1
2
3
4
5
6
7
8
9
10
11
12