9.3.1
Removing the Key Switch
Caution – Ensure that the power to the system is off. See the Sun StorEdge 6320
System Installation Guide for instructions about powering off the system.
1. Disconnect the key switch cable connector from the adapter-cable connector near
the back of the power sequencers (
The adapter cable remains connected to the power sequencer.
FIGURE 9-3
2. Facing the back of the key switch on the inside of the system, use a pair of needle-
nose pliers to slide out and remove the metal clip that secures the key switch to
the system (
9-6
Sun StorEdge 6320 System 1.0 Reference and Service Manual • May 2003
Key switch
cable connector
Key Switch Cable Connector Location
).
FIGURE 9-4
).
FIGURE 9-3