Modifying A Storage Pool; Deleting A Storage Pool - Sun Microsystems StorEdge 6320 System 1.0 Reference And Service Manual

TABLE 5-13
Argument
-r,--raidlevel
{0 | 1 | 5}
-s,--spare {0 | 1}
pool pool-name
5.3.6.2

Modifying a Storage Pool

Use this command to modify the state of a storage pool, placing the pool storage
online or offline. The sscs modify pool command-line syntax is shown below.
# sscs modify -a array-name -s {online | offline} pool pool-name
TABLE 5-14
TABLE 5-14
Argument
-a,--array array-name
-s,--status online
-s,--status offline
pool pool-name
5.3.6.3

Deleting a Storage Pool

Use this command to delete a storage pool that exists in a specified Sun StorEdge
6020 array. The sscs delete pool command-line syntax is shown below.
# sscs delete -a array-name pool pool-name
sscs create pool Command-Line Arguments
Description
Specifies RAID levels 0, 1, or 5.
Specifies if the pool contains a spare drive: specify 1 if the
pool contains a spare, 0 if it does not contain a spare.
Specifies a pool-name up to 12 characters long.
describes the arguments associated with the modify pool subcommand.
sscs modify pool Command-Line Arguments
Description
Specifies an array-name up to 40 characters long.
Place the pool online
Place the pool offline
Specifies a pool-name up to 12 characters long.
Chapter 5 Sun StorEdge Configuration Service Software 5-21