Sun Microsystems StorEdge 6320 System 1.0 Reference And Service Manual page 155

19. Set the password.
Most Sun StorEdge 6020 arrays do not have a password set when they are delivered.
Arrays that are not new should also have the password cleared.
Leave the "Old Password" field blank if the array was delivered without a
password. Change the "New Password" pulldown menu to be "Saved Password"
and leave the field blank. The factory-set password will continue to be used for all
arrays.
20. Create a new system inventory snapshot.
Select Manage → Service → Inventory Maintenance and click Generate New
Inventory. Once the inventory is generated, click Save Inventory.
21. Configure the Sun StorEdge 6020 array
Select Manage → Service → Configure Devices" and click Configure All.
22. Verify and fix the firmware revisions for the replacement array.
Select Manage → Service → Revision Maintenance and click Create Patch Report.
This verifies the Sun StorEdge 6020 array has the most recent patches applied.
Click Select Patches. Check to see if any of the patches are listed for the replacement
array. The list is presented with the names of the arrays and which patches are
needed. Select the patches that you want to apply. The Patch Installation Report
generates a log of the changes that have been applied.
Chapter 12 Servicing Sun StorEdge 6020 Arrays 12-13