First Time Installation - Luxor LX9411962DVD Operating Instructions Manual

• After you have selected a programme in EPG menu,
press the OK button and and Options screen will
be displayed. Select "Record" option and press the
OK button. After this operation, a recording becomes
set to the selected programme.
• To cancel an already set recording, highlight that
programme and press the OK button and select
the option "Delete Rec. Timer". The recording will
be cancelled.
Note: You cannot switch to any other channel or
source while there is an active recording on the
current channel.
Set Timer / Delete Timer
After you have selected a programme in EPG menu,
press the OK button and and Options screen will
be displayed. Select "Set Timer on Event" option
and press OK button. You can set a timer for future
programmes.
To cancel an already set reminder, highlight that
programme and press the OK button. Then select
"Delete Timer" option. The timer will be cancelled.
Note: It is not possible to record or set timer for two or
more individual events at the same time interval.

First Time Installation

IMPORTANT: Ensure that the aerial or cable is
connected before switching on the TV for the first
time installation.
• When the TV is operated for the first time, the
installation wizard will guide you through the
process. First, the language selection screen will
be displayed:
• Use " " or " " buttons to select your language
and press OK button to set the selected language
and continue.
• After selecting the language, "
be displayed, requiring you to set Country,Teletext
Language and Scan Encrypted options.
Welcome!" screen will
English
• By pressing " " or " " button, select the country
you want to set and press " " button to highlight
Teletext Language option. Use " " or " " button
to select desired Teletext Language.
• Press " " button after setting Teletext Language
option. Scan Encrypted will be then highlighted.
You should set the Scan Encrypted as Yes if you
want to scan coded stations.Afterwards select the
desired Teletext Language.
• Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
To select the "Yes" or "No" option, highlight the item by
using " " or " " buttons and press OK button.
Afterwards, the following OSD will be displayed on
the screen:
If you select CABLE option, the following screen will
be displayed:
You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
- 100 -