Programming The Memory Feature; Linking And Unlinking The Remote Keyless Entry Key Fob To Memory - Dodge RAM TRUCK 15002017 Owner's Manual

Programming The Memory Feature

To create a new memory profile, perform the following:
1. Cycle the vehicle's ignition to the ON/RUN position (do
not start the engine).
2. Adjust all memory profile settings to desired prefer-
ences (seat, side mirrors, adjustable pedals and radio
station presets).
3. Push and release the S (set) button on the memory
switch.
4. Within five seconds, push and release either of the
memory buttons (1) or (2). The instrument cluster dis-
play will show which memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory
profile.
• To set a memory profile to your key fob, refer to
"Linking And Unlinking The Remote Keyless Entry Key
Fob To Memory" in this section.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 129
Linking And Unlinking The Remote Keyless Entry
Key Fob To Memory
Your key fobs can be programmed to recall one of two
pre-programmed memory profiles by pushing the unlock
button on the key fob.
NOTE: Before programming your key fobs to memory the
feature has to be selected.
• If your vehicle is equipped with a touchscreen, you must
select the "Memory To Fob" feature through the
Uconnect system. Refer to "Uconnect Settings" in "Un-
derstanding Your Instrument Panel" for further informa-
tion.
• If your vehicle is not equipped with a touchscreen, you
must select the "Key Fob Linked To Memory" feature
through the instrument cluster display. Refer to "Instru-
ment Cluster Display" in "Understanding Your Instru-
ment Panel" for further information.
3